Timing control (Because the ion activity sensor is very insensitive, timing control is prioritized.)
Materials: timer (floating hourglass), redstone repeater, replace the ME input bus for fuel with ME stock input bus,ME trigger bus, transmitter.
Set the timer with a longer pulse duration, to avoid the pulse being too short and causing it to fail to run.
Machine control cover settingInverted.
Distilled water does not need to be input too much (around 10B-100B).
The trigger bus and the transmitter are both attached to the front of the inventory input bus.
The transmitter is set to release X-polar liquid and emits a redstone signal when the amount is greater than the set value.
The purpose is to avoid pulling a small amount of fuel, causing a little waste.
Note: The transmitter should not be in the main network; it's best to set up a separate subnetwork.
Non-timed control (Not recommended, but necessary.)
Working principle of ion activity sensor
Under Normal difficulty, the efficiency of the PTFE membrane electrode is 420%, and the corresponding sensor value is the maximum value of 4.2.
Under Expert difficulty, Fuel Cell Mode 1 will have anextra efficiency bonus (Expert perk?), so please defer to what is shown in the machine controller.
Supercool trivia: when players have made the organic liquid-flow energy-releasing liquid, they can already make the highest-tier membrane electrode; the highest tier has norunning loss(Expert mode does not have this).
Prepare materials
ME Input Hatch (2), Ion Activity Sensor (1), Machine Control Cover Plate (2), Red Alloy Wire;
Homework display (I know, actually you just want to see the answer)
Non-timed control
Principle: When fuel efficiency decay reaches the set value, output a redstone signal, close the fuel input chamber, and open the distilled water input chamber.
Don't use inventory input to pull fuel! Inventory input has no cache, which will cause the device to fail.
The more distilled water is input, the faster efficiency is repaired.
Attached is a fuel chamber diagram (in case someone doesn't know how to set it up)
Transmitter control
Just make sure to use up all the fuel with each run
will complete the cleaning action and run again
The example I have here is 5B zinc iodine to 100B t5 oil
The ratio can be increased as long as it is ensured that the fuel is completely used up in each run.