(0.5.4)外置热源锅炉自动控温方案
Available in English
A complete English translation of this article is available.
群友方案（群友杀疯了）
来自群友“我有几分似从前”的高度压缩自动控温，杀疯了
比较器可以去结构里面摸，活塞(位于两侧)使用普通活塞即可，红石粉位于外置热源锅炉上，比较器位于加热器上，活塞上的红石线路为停机用
p.s.活塞头也能堵住加热器，真神秘啊
记得安全生产（好长）
在正式生产之前，请务必认领区块防爆，确认各锅炉状态和连接情况，第一次试运行务必时刻监管并提前运行backup以避免损失，如果炉温超过570度说明红石控制布置有误，请立即拆除或阻挡加热器避免爆炸
P.S.卸载复位
粘性活塞结构在区块卸载（进出存档）时可能会卡在关闭加热状态，通过短脉冲复位即可
Comments
5- Anonymous 85606/06/2026
Version 0.5.6 After testing, it was found that the boiler's maximum output is 14 redstone signal. The red alloy wire from the More Red mod also has a maximum output of 14. If you are using the vanilla redstone directly, note that the comparator's side input needs to be set to 14, otherwise, the temperature control will fail and it will explode.
- Anonymous 18706/06/2026
What is the principle?
- Anonymous 85606/06/2026
The boiler outputs a Redstone signal proportional to the temperature. A comparator is used to set a fixed value signal. Once reached, it can be output to a piston. When the piston blocks the heater, heating stops.
- Anonymous 79806/06/2026
Version: 0.5.5 beta Tested, the piston is triggered only when the furnace temperature is greater than 580. The description of the furnace temperature limit in the tutorial is incorrect. Additionally, the wire above the redstone block is Red Alloy Wire (More Red mod).
- Anonymous 88506/22/2026
Version 0.5.6pre3, Expert Mode. The current version of the boiler requires a heat sensor cover plate to output a redstone signal. The cover plate requires an assembler to obtain. ULv voltage is sufficient.
Your comment appears under your display name.