GTO Team
(0.5.4) External heat source boiler automatic temperature control scheme

(0.5.4) External heat source boiler automatic temperature control scheme

GuideVoltage ULVPublished 05/12/2026
ContributorsAnonymous 716

Group members' plan (group members are on a killing spree)

Highly compressed automatic temperature control from group friend 'I Have a Bit Like Before', it's going crazy

Comparator can be touched inside the structure, pistons (located on both sides) use normal pistons, redstone dust is on the external heat source boiler, comparator is on the heater, the redstone line on the piston is for shutdown.

p.s. The piston head can also block the heater, really mysterious.

Remember safety production (very long)

Before formal production, be sure to claim the block explosion prevention, confirm the status and connections of each boiler. During the first test run, always monitor and run backup in advance to avoid losses. If the furnace temperature exceeds 570 degrees, it indicates an error in the redstone control layout. Please immediately remove or block the heater to avoid explosion.

P.S. Uninstall Reset

When the sticky piston structure is unloaded (entering/exiting save), it may get stuck in a closed heated state; it can be reset with a short pulse.

Comments

5
  • Anonymous 85606/06/2026

    Version 0.5.6 After testing, it was found that the boiler's maximum output is 14 redstone signal. The red alloy wire from the More Red mod also has a maximum output of 14. If you are using the vanilla redstone directly, note that the comparator's side input needs to be set to 14, otherwise, the temperature control will fail and it will explode.

    • Anonymous 85606/06/2026

      The boiler outputs a Redstone signal proportional to the temperature. A comparator is used to set a fixed value signal. Once reached, it can be output to a piston. When the piston blocks the heater, heating stops.

  • Anonymous 79806/06/2026

    Version: 0.5.5 beta Tested, the piston is triggered only when the furnace temperature is greater than 580. The description of the furnace temperature limit in the tutorial is incorrect. Additionally, the wire above the redstone block is Red Alloy Wire (More Red mod).

  • Anonymous 88506/22/2026

    Version 0.5.6pre3, Expert Mode. The current version of the boiler requires a heat sensor cover plate to output a redstone signal. The cover plate requires an assembler to obtain. ULv voltage is sufficient.

Your comment appears under your display name.