[0.5.6beta] Simple solution for neutralization of water to amphoteric water (4-6) in pH

Foreword

I found that the level 4 to 6 purifications have very concise and beautiful solutions, which are very pleasing.

[4] PH Neutralization and Purification Device

Use four Redstone wire columns, connected crosswise. Mark the left ME input bus "5 NaOH powder", mark the right ME input hopper "50mb Hydrochloric Acid". Both input buses (hoppers) should have a Machine Control Cover applied to the center face, with the Machine Control Cover set to "1 - Invert".

The following two PH sensor parameters are Normal - 6.6 - 9.5 ; Normal - 0.0 - 6.95

The reason the left sensor is not 7.05 - 9.5 is that the Redstone line has a signal attenuation of 1. If it is changed to Redstone p2p, there will be no attenuation, but it will not look good. Anyway, adjusting the values will have the same effect.

[5] Extreme Temperature Fluctuation Purification Device

Use two redstone torches, one redstone repeater base, and one latch to complete.

The sensor parameters above and below are: Normal - 10000 - 11200 ; Normal - 0.0 - 10.0

The input chambers for helium plasma and liquid helium are both covered with machine control covers on the side (the side indicated by the red line in the figure), and both are set to 1 - inverse phase.

Helium plasma is set to 13mb helium plasma input, liquid helium can be directly used from stock input, or mark larger values, i.e. excess input

During normal operation, the temperature will cycle three and a half times. Controlling the helium plasma input allows it to cycle just over three times, saving some helium plasma.

[6] High-energy laser purification device

Using 11 super boxes, Ouroboros-style input/output

The crystal resonant generator is in the middle, me interface (only one slot left, the other eight slots are filled with trash), storage bus (whitelist all lenses or inverse cards marking trash), output bus (whitelist all lenses, redstone card set to pulse activation)

Note that he cannot use gemstone lenses; all colored lenses must be stained glass lenses.

Manually pull the lever for calibration during the first run, and it will run continuously afterwards.

Ramblings about Level 7 Water

The current version gives you unlimited Level 8 water components for making one Level 7 water, so you don't actually need to make Level 7 water. Just input two buckets of water each time and wait for it to randomly require air, or you can manually feed materials, which is also perfectly fine.

My first time making degassing water, I overthought it. I thought it required a change in demand every second, consumption of materials every second, and a run time of 120 seconds without errors to produce. So I made a device that met these conditions...

The principle of this device is that two machines control cover plates, set to be lower than x+1 and not lower than x respectively. This ensures activation of the super cylinder output only when the signal is x. The super cylinder can also have its capacity capped. Thus, when receiving signal x, the corresponding super cylinder outputs once per second (its output CD is 1s), and the output goes into the machine's input bin.

Turns out he just randomly needed some liquid during a run, and the liquid only needed to be entered once. Damn it.