Flocculation water automation, only needs simple hourglass and machine control cover plate
Flocculation water automation, only needs a simple hourglass and machine control cover plate
The English translation is incomplete
6 of 13 blocks have no English translation yet and are shown in the original language.
Machine translation
Parts of this page's English were produced automatically by the translation service.
The automation requirement for Flocculated Water is to sequentially input 100b of the required liquid within 120s for water purification. Each input of 100b increases the success rate by 10%.
Then prepare 2kb of Polyaluminium Chloride Liquid, and then make a Requester. Maintain 1kb within the network, or conservatively 2kb.
and the treatment of flocculant waste liquid. 2 16aEv energy storage.
Just set 100b Polyaluminium chloride in the ME Input Bus, place 11 sand on top of the hourglass, and add the machine control cover plate on top. The machine cover plate is an inverted high signal strength.
11 sand aiming at the main block machine restart at 0s.
Then there are no major problems.
The only thing to pay attention to is when replacing the energy storage on the main block, be careful to readjust the hourglass time.
Comments
0Nothing here yet. Say the first thing.
Your comment appears under your display name.