(ULV) Alchemy Pot Temperature Control Device

0.5.6p3 updated the heat mechanism, a new item is needed to make the heater emit a signal (heat detection cover plate). If you don't have it, you can ignore this item.

• Place the alchemy pot on top of the heater, and the temperature will not exceed 558.

• The temperature is controlled around 747-755 (14 Redstone signals).

• You can adjust the redstone signal input to the redstone comparator according to your needs.

• Redstone 13 - Temperature 700 / Redstone 14 - Temperature 750

• Diagram (Redstone torch and two redstone dust)

Heat Detector Cover Plate Redstone Comparator One Side

• If the temperature rise is slow, what should you do? You can add a heater.

Normal heat pipes need to be connected to the top of the heater, while the alchemy pot needs a heat pipe at the bottom.

This device can keep the alchemy cauldron at a temperature of 700-759. (If you think it's not enough, you can add more yourself.)

Note: The machine will pause if the front of the heater is blocked.

Electric Heaters can only export heat from the top. Attach a Heat Exchanger to the side of the Chemical Reactor and connect it with a regular Heat Pipe. (Alchemy Table does not require a Heat Exchanger, attach directly)

Can be connected freely, but it is not recommended to connect too many, as too much dispersion will prevent high temperatures from being obtained.

Deprecated, the new Alchemical Chest will no longer explode due to excessive temperature.

Old Version

New version (Redstone Wire)

New version (Redstone Alloy Wire)