Guide#50English
Automated ae order placement before the large magic line machine

Automated ae order placement before the large magic line machine

Considering that making magic-side large machines requires handcrafting a large amount of materials, it is a good choice to first achieve basic automation to order large machines. Common magic-side synthesis recipes are selected for automation here. Better automation methods may exist, and discussion is welcome.

1. Mana pool automation (Mana steel, Mana diamond, Mana pearl, etc.)

Build as shown in the figure, where the item collector can be replaced with a backpack (magnet upgrade), and filter the products.

Leave a one-block gap between the flower pattern box and the mana pool to allow products to scatter, and surround it with glass etc. (leave one block for mana input).

Automated ae order placement before the large magic line machine

Write the corresponding template:

Automated ae order placement before the large magic line machine

2. Elf Gate Transaction

Build as shown. The template supplier is attached to the dropper. After the comparator detects an item, the piston pushes the face-to-face observers to generate a high-frequency signal.

Filter the products in the item collector, and at the same time be careful not to get too close to the mana pool automation, otherwise thrown materials such as mana steel may be sucked away.

The back of the spirit door needs to be blocked with a block to prevent the product from flying away.

Automated ae order placement before the large magic line machine
Automated ae order placement before the large magic line machine

3. Rune Altar Automation

As shown in the construction, the principle: The template sends materials to the container, the living rock is filtered to the upper dispenser, the remaining materials are sent to the lower dropper, which is continuously triggered by the suspension hourglass, sending materials to the rune altar. The front of the rune altar receives mana input. When full, a comparator can emit a 2-block redstone signal, which is turned into a pulse signal through a pulse gate (actually, you can replace it with a repeater as well). Launch the living rock and use the dispenser to use the forest staff.

Note: The hopper on the left of the item collector is necessary, and the item collector uses a small tin item pipe for output, and automatic output cannot be enabled. These two steps are to create a delay, because the rune altar has a built-in cooldown after completing a synthesis. If items are launched immediately at this time, they will fall out and cause a bug.

Automated ae order placement before the large magic line machine
Automated ae order placement before the large magic line machine

4. Automation of the New Magic Enchantment Room and Infusion Room

Use AE subnet + storage bus to change priority.

Contributors

Comments

0